ABSTRACT
Compound die is an efficient and precise provision of normal stamp die. For
the part can not finished in only one stamp working procedure，it is better machining on the compound die according to the technical demands of the part. In the thesis, designed a compound mold used to machining the half-finished clutch shell. This set of mold suits in the clutch shell punch central hole, stamp bottom convex shape, and shave fringe, after that still had several processing working procedures. When carries on the design of this compound mold, the main question is to confirm the way of stamp the bottom convex figuration. Because it is have to guarantee the fore working procedure’s approximate shape precise, uses partial-undulate stamp in here to processing the bottom bulge. Therefore, the key role to succeed of the partial-undulate stamp is to define reasonable blank holding force. At the same time, when stamped conical convex bulge, the design of convex-concave die is also important. In order to the standardized design, has selected the standard part as far as possible. Such as die frame, die bed plates, press machine and so on. Finally, set down the machining technical procedure of sleeve, a major mold component. The design in the thesis has some referenced value for analogical calendaring molding design.
豫公網安備 41072402000322號
熱門關鍵詞：
